Electrodes ЦЛ-17

WELDING ELECTRODES TSL-17 (diameter 3; 4; 5 mm)

CLASSIFICATION: E-10H5M8 in accordance with GOST 9466-75

LEGEND: E-10H5MF-TSL-17- Ø - TD
                               E-00-B20

TECHNICAL REQUIREMENTS: GOST 9466-75, TU BY 100034500.045-2013

COATING: main

PURPOSE:

For the welding of chromium-molybdenum steels 15X5M marks 12H5MA, 15H5MFA working in hostile environments at temperatures up to 450 ° C. In all spatial positions except the vertical "top-down", at a constant current of opposite polarity.

After welding, the required heat treatment of products at temperatures 750-760 ° C with an exposure not less than 3 hours, followed by cooling to 500 ° C in an oven, then cooled in air.

CHARACTERISTICS Electrodes:

arcing	sustainable
splashing degree	small
formation of the joint	a good
Separation of the slag crust	satisfactory
deposition rate (in the lower position of the weld)	10.0 - 12.0 g / Ah
deposition rate (electrode diameter 4.0 mm)	1,5-1,7 kg / h
Electrode consumption per 1 kg of weld metal	1.6 kg

Typical mechanical properties of weld metal (at 20 ° C):

Tensile strength, MPa	Relative extension, %	Impact toughness J / cm2
550	15	65

Chemical composition of deposited metal:

Element content, weight%
Carbon	Silicon	Chromium	Manganese	Molybdenum	Vanadium	Sulfur	Phosphorus
0,07-0,13	0,15-0,45	4.0-5.5	0.5-0.9	0,35-0,65	0,10-0,35	<= 0.025	<= 0.035

DIRECTIONS FOR USE

Recommended short arc welding is necessary pre-heating and the accompanying articles to 350-400 ° C.

In case of exceeding the permissible moisture content in the coating (0.7%) before use further electrodes are calcined at a temperature of 250-300 ° C for 40-60 minutes.

WELDING MODES:

Electrode diameter mm	Welding current, A
	joint position
	Underwear	vertical	ceiling
3	90-120	80-100	80-100
4	130-160	120-150	120-150
5	180-220	170-200	-

= / + /